Published at Thursday, December 14th 2017. by Dawn Juarez in Home Design.
The structure over the hangar door is an important consideration. Hangar doors are usually quite wide varying from a minimum of 40 feet on up to greater than 55 feet wide. The header or beam spanning across the top of the door needs to be considered structurally. One way to handle this is by placing a steel I-beam across the door which will hold the weight of the roof. There are several disadvantages to this including higher construction costs due to the steel fabrication issues. Another disadvantage is that the beam bottom will usually fall well below the ceiling of the hangar causing the hangar door to be shorter than the ceiling height. Another, perhaps better, way to handle this is to use some sort of a gable roof or a modified gable roof over the hangar door. This allows the truss system of the roof to act as its own beam. Often the truss that spans over the door is a multi-ply truss and its bottom can be even with the ceiling height of the hangar. This allows the door to be higher and nearly the same height as the ceiling of the hangar. When designing the hangar discuss this aspect with the designer engineer who will work with you to determine the best solution.
The area that received the most attention was the kitchen. 22 percent of respondents in the A.I.A report said the size of the kitchen is increasing in new home design and construction. The rediscovered focus on size opens up the possibility of remodeling and addition work that can be done in this popular and lucrative sector. The dominant feature requested for new kitchens are renewable materials. Almost half of the surveyed architects said that materials such as bamboo, cork and concrete are becoming increasingly popular.
Focus on lighting--both artificial and natural light. The home can never have too much light, and so the budget should allow for numerous light sources throughout the home, from one room to the next. Keep in mind that one central ceiling-mounted light fixture just wont do, and instead, aim for six light sources per room. As for natural light, with all the advances in insulated windows today, choose a design that lets the sun shine in through as many openings as possible.
Because lot sizes vary from large to small, setbacks may be an issue. Another factor is whether or not the site is level or has a slope. Sloped sites are quite workable but present unique challenges that must be considered. Generally on sloped lots the hangars are placed on the lower section and the home on the higher section which allows the home and hangar to blend with one another nicely.
Place the main furniture first: One of the most effective home designing tips to avoid cluttering at your home is to place the main and the most important furnishing first. For example, beds, couches, desks at all should be placed first and at the center of the room so that enough space is left for the placement of the rest of the furniture. Make sure that large pieces of the furniture are evenly placed in the room to strike the right balance. After the placement of the main pieces is done, then place the rest of the sundry furniture to ensure smooth flow of the traffic in the room.
There are few more unique lifestyles than living in an airport community. The designing of a hangar home is a unique skill and one best handled by professional designer well experienced in the subject. In this article we will cover a few specific points that you will value as suggestions to consider.